点击图片查看大图|
|
|||||
|
|||||
| Physical properties of TEVOE PA12 MT90 | |||||
|
The characteristics of MT90
|
|||||
| High transparency, high rebound elasticity, low shrinkage, good performance, anti impact fatigue durability of durable, chemical properties, high dimensional stability | |||||
|
The main application of MT90
|
|||||
|
High function products MT90 is mainly applied to optical and plastic injection molding, which comprises a spectacle |
|||||
| Property | Method | Condition | Unit | Value | |
| Specific gravity | ISO1183 | g/cm3 | 1.03 | ||
| Total light transmittance | ISO13468 | 3mm | % | 90 | |
| Haze | ISO14782 | 3mm | % | <1 | |
| Refractive index | ISO 489 | nd | - | 1.23 | |
| water absorption | ISO 62 | 24hr | % | 0.3-0.5 | |
| Heat distortion temperature | ISO75-2 | 1.8Mpa | ℃ | 120 | |
| Tensile strength | ISO527-2 | 1A/5 | Mpa | 78 | |
| Elongation | ISO527-2 | 1A/5 | % | 200 | |
| Izod impact strength | JIS D7110 | 1A | J/m | 760 | |
| Flesural Modulus | DIS K7111 | 1eA V notched | Pma | 1760 | |
| Shore hardness,methld A | ISO868 | A/D | 82 | ||
| Thes values mentioned above are average values and shuold not be used for guaranteed specification purpose. | |||||
|
|
|||||
| Physical properties of TEVOE PA12 MT90 | |||||
| Processing conditions for test specirnens | |||||
| Injection | Nominal Value Unit | ||||
| Drying Temperature | 90-100 ℃ (Vacuum dryer) | ||||
| Drying time | 6 to 10 HR | ||||
| Suggested Max Moisture | <0.1% | ||||
| Processing(Melt)Temp | 235 to 270 ℃ | ||||
| Imjection Pressure | Medium to high speed | ||||
|
The matters needing attention:
|
|||||
|
MT90 in the factory has been fully dry, moisture content of less than 0. 1%, packaging in the vacuum bag, without drying can directly produce. |
|||||
| If the package is damaged material exposure time in the air for too long. MT90 will suck the moisture in the air, moisture content of material is too high, in the injection process, will cause the material overflow in the molten state. The formation of water streak on the surface of the product. At this time, must carry out the drying process: 100 degree vacuum drying 6-10 hours. | |||||
免责声明：（1）以上所展示的信息由企业自行提供，内容的真实性、准确性和合法性由发布企业负责，环球塑化网对此不承担任何保证责任。我们原则上建议您优先选择“塑企通”会员合作! （2）同时我们郑重提醒各位买/卖家，交易前请详细核实对方身份，切勿随意打款或发货，谨防上当受骗。如发现虚假信息，请向环球塑化网举报。
簡繁切換